Sany SW976K wheel loader pdf operation and maintenance manual
Format: PDF
Pages: 216
File size: 11.97 MB
Language: English
Models: SW976K wheel loader
Table of Contents for SANY-SW978K-OM-EN manual
- Table of Contents
- 1. Preface
- 1.1 Preface
- 1.2 Introduction
- 1.3 Safety information
- 1.4 Product information
- 2. Safety
- 2.1 Safety nameplate
- 2.2 Safety information
- 2.3 Operate the machine safely
- 2.4 Safe maintenance instructions
- 2.5 Conclusion
- 3. Specifications and Dimensions
- 3.1 Technical specification
- 3.2 Technical parameters
- 4. Operation
- 4.1 General drawing of machine
- 4.2 Description of control devices and instruments
- 4.3 Operation and control of the machine
- 4.4 Transportation
- 4.5 Lifting
- 5. Maintenance
- 5.1 Maintenance guide
- 5.2 Disposal of oil, fuel and coolant
- 5.3 Maintenance of electrical system
- 5.4 Wearing parts
- 5.5 Recommended fuel, coolant and lubricating oil
- 5.6 Tightening torque
- 5.7 Key safety parts
- 5.8 Maintenance plan
- 5.9 Maintenance procedure
- 6. Fault Diagnosis
- 6.1 Special instructions
- 6.2 Precautions during fault diagnosis
- 6.3 Inspection before fault diagnosis
- 6.4 Treatment scheme for common non-quality problems
- 6.5 When charging the battery with low state of charge
- 6.6 When the machine cannot be started due to low battery level
- 6.7 When engine water temperature is too high
- 6.8 When engine oil pressure (low pressure) is abnormal
An Operation & Maintenance Manual is the essential guide for every machine operator and owner. It provides the fundamental knowledge required to keep your equipment running safely and efficiently. Unlike technical repair books, this manual focuses on preventive maintenance and correct daily usage.
Key topics covered in this manual:
-
Safety Precautions: Critical guidelines for protecting the operator and the machine.
-
Operating Instructions: Detailed breakdown of controls, instruments, and handling techniques.
-
Maintenance Intervals: A complete schedule for oil changes, filter replacements, and lubrication points.
-
Capacities & Specifications: Exact data on fuel, hydraulic fluids, and coolant requirements.
Following the official Operation & Maintenance Manual is the best way to maximize the lifespan of your equipment, ensure warranty compliance, and maintain a high resale value.