Wirtgen W60i, W100i (12.10) milling machine pdf operation and maintenance manual

Table of Contents for WRT-2236241-00-EN manual

• CONTENTS
• 1 General
  • 1.01 Preface / introduction
  • 1.02 Use
  • 1.03 Climatic conditions
  • 1.04 Safety instructions
  • 1.05 Noise / vibration
  • 1.06 Labelling
• 2 Description
  • 2.00 General
  • 2.01 Chassis / safety devices
  • 2.02 Operator's stand
  • 2.03 Milling drum unit
  • 2.04 Engine / motor group
  • 2.05 Hydraulic oil feed
  • 2.06 Electrical system
  • 2.08 Advance drive
  • 2.09 Steering system
  • 2.10 Conveyor unit
  • 2.11 Levelling system
  • 2.12 Water system
  • 2.40 Special equipment
• 3 Operation
  • 3.00 General
  • 3.01 Programmable logic control (PLC)
  • 3.02 Diesel engine
  • 3.03 Milling drum unit
  • 3.04 Travelling / steering
  • 3.05 Height adjustment / levelling
  • 3.06 Conveyor unit
  • 3.07 Water system
  • 3.08 Special equipment
• 4 Maintenance
  • 4.00 General
  • 4.01 Chassis / safety devices
  • 4.03 Milling drum unit
  • 4.04 Engine / motor group
  • 4.05 Hydraulic oil feed
  • 4.06 Electrical system
  • 4.07 Water filter
  • 4.08 Advance drive
  • 4.10 Conveyor unit
  • 4.12 Water system
  • 4.18 Lubrication unit
• 5 Charts
  • 5.01 Maintenance
  • 5.02 Technical data
  • 5.03 Fuels / lubricants
  • 5.04 Tightening torques
  • 5.05 Frost protection
  • 5.06 Operating state messages
• 6 Installation, assembly and conversion instructions, set-up tasks
  • 6.00 General
  • 6.01 Programmable logic control (PLC)
  • 6.02 Diesel engine
  • 6.03 Operator's stand
  • 6.04 Milling drum unit
  • 6.05 Hydraulic oil feed
  • 6.06 Height adjustment / levelling
  • 6.07 Conveyor unit
  • 6.08 Water system